mfr

美 　英

• abbr.(=manufacturer)
• 網絡熔體流動速率(Melt Flow Rate)；熔體質量流動速率；最大尿流率(Maximum Flow Rate)

英漢解釋

abbr.

1. (=manufacturer)

英英解釋

abbr.

1. (=manufacturer)

例句

Responsible for NTL-DG ET issue root cause investigation and analysis, drive for short term MFR improvement by cooperate with product team.

ET事件（產品緊急事件）根本原因的調查分析，通過與產品團隊的合作來驅動制造壞品率的短期改善活動。

Incorporator Changes , Items, Mfr Parts, Manufacturers, Prices.

組件工程師項目，制造商，制造商零件。

The influence of MFR of PP and mixing technology on the properties of the special material is discussed.

探討了PP的MFR，以及擠出共混工藝對專用料性能的影響。

The melt flow rate (MFR) impacting to crystallinity and properties of polypropylene (PP) was studied.

研究了聚丙烯（PP）熔體流動速率（MFR）對結晶度及性能影響。

The crystallinity of polypropylene with different melt flow rate ( MFR ) are measured by X-ray method.

用X射線法測定了不同熔體流動速率下聚丙烯材料的結晶度。

The effects of stabilized a-gent, MFR and melt temperature on degrading behavior were discussed.

對助劑量、熔體溫度等工藝條件對降解行為的影響進行了討論。

It was showed that crystallinity of PP increased with the MFR rising.

結果表明，隨著PP的MFR上升，其結晶度增加；

In the extrusion composite technology selection and not in the MFR (MI) is too small of resin.

在擠出復合工藝中，不宜選用熔融指數（MI）太小的樹脂。

The MFR 3 is available for one (MFR 31) or two (MFR 32) circuit breakers.

該生產商三供一（生產商31日）或2（生產商32）斷路器。

Donations of $10 can be made by texting "MFR" to 85944.

發送MFR到85944就可以捐款10美元。

The results showed the MFR of carrier resin had obvious effects on the quality, processability and application of CMB;

結果表明：載體樹脂MFR的差別對色母粒的質量、加工性能和應用影響較大；

Modeling of Bulk Propylene Polymerization in Loop Reactor and MFR Prediction

本體法環管式丙烯聚合過程建模和MFR預報

Soft Measurement of Polypropylene MFR

聚丙烯熔融指數軟測量