voltmeter

美 [?vo?lt?mit?r] 　英 [?v??lt?mi?t?(r)]

• n.電壓表；伏特計
• 網絡電壓計；伏特表；電壓電量計

詞形變化

復數：voltmeters  

英漢雙解

英漢解釋

n.	1. 【電】電壓表,伏特計

英英解釋

n.	1. a piece of equipment used for measuring voltage

例句

To obtain a KVL equation, we must tally voltage drops in a loop of the circuit, as though we were measuring with a real voltmeter.

要獲得一個KVL方程式，我們必須計算該回路中某一環路中的電壓降，好像我們是在用一臺真正的電壓表進行測量一樣。

The range of a voltmeter may be extended by means of a series resistor called a multiplier as shown in FIG.

如圖2所示，采用一種稱為倍增電阻的串聯電阻器即可擴大伏特表的量程。

A voltmeter is an instrument used for measuring the electrical potential difference between two points in an electric circuit.

伏特計是用于測量電路中兩點之間電勢差的儀器。

The holiday detector shall be checked with a DC voltmeter at least once each shift to ensure accuracy.

應至少在每次換班時用直流電伏特計檢查一次漏涂檢測儀以確保其準確度。

The frequency at which the voltmeter's response to an AC signal drops to 70% is often denoted as the "3dB point" (f3dB).

電壓表對交流信號的響應降低到70%時的頻率常常稱為“3dB點”（f3dB）。

Our end-users consider the Voltmeter to be unfit from application and claim that the instrument to be replaced by you with a sound one.

我方用戶認為該電量計不適于使用，要求你方用一只好的替換。

If the current cannot be reduced, use a narrow current pulse and a fast responding voltmeter.

如果不能降低電流的話，使用窄的電流脈沖和快速響應的電壓表。

Ideally, when a voltmeter is connected to a relatively low impedance circuit in which no voltages are present, it should read zero.

在理想的情況下，當把電壓表連接到一個沒有電壓的、阻抗比較低的電路時，電壓表的讀數應當為零。

The panel is placed in a solar simulator. Negative and positive contacts of the solar panel are connected to a voltmeter.

把板放置在一個太陽模擬器中。無論是與太陽能電池板正面或者反面接觸，都連接到電壓表。

The paper mainly discusses the design principle and chief techniques of a high accuracy programmable digital voltmeter.

本文論述了高精度程控數字電壓表的設計原理及實現的方法。

Another consideration when measuring voltages from high resistance sources is the input bias current of the voltmeter.

在測量高電阻源時要考慮的另一個問題是電壓表的輸入偏置電流。

The circuit of the electrometer when used as a voltmeter is actually as shown in Figure 2-6.

當靜電計作為電壓表使用時，其電路實際上如圖2-6所示。

The BNC jack can be connected to a scope or a true-RMS AC voltmeter to measure the degree of imbalance.

是的BNC插孔可以連接到范圍或一個真正的有效值交流電壓表測量程度的不平衡。

It is convenient to include the functions of a voltmeter , ammeter, and ohmmeter within one instrument.

人們把伏特表，安培表，歐姆表集中在一只儀表內是非常方便的。

Operation can be conducted after the indicating value of direct current voltmeter of the panel is zero.

待面板的直流電壓表的指示值為0時方可進行操作。

However, in spite of all this similarity between a voltmeter and an ammeter there are also important differences.

可是盡管伏特表與安培表之間有這些類似之處，但還有若干重要的差別。

To measure the potential difference, a voltmeter is connected across the coil.

（狀語）伏特計跨接在線圈兩端，以便測量電位差。

To reduce error due to voltmeter non-ohmic contacts, use shielding and appropriate grounding to reduce AC pickup.

為了降低電壓表的非歐姆接觸所產生的誤差，采用屏蔽和適當的接地措施來降低交流干擾。

I graduated from the core task is to design: FPGA to create a VHDL-based language of the digital voltmeter.

我的畢業設計的核心任務是：采用FPGA來制作一個基于VHDL語言編寫的數字電壓表。

The offset voltage will cause an error in the applied stimulus to a device under test or the value measured by the voltmeter.

偏移電壓會導致施加到被測裝置的激勵發生誤差，或者使伏特計的測量值發生誤差。

Low-cost DVM (digital-voltmeter) modules are economical and can significantly reduce design time for instrumentation.

廉價的DVM（數字電壓表）模塊經濟，能顯著減少儀器的設計時間。

Voltage is measured with a voltmeter, connected in parallel.

電壓應并聯在電路中的電壓表來測量。

The testing system was composed of signal amplifer, digital voltmeter, data acquisition unite and computer.

由信號放大器、數字電壓表、數據采集器、計算機等組成測量系統。

The voltmeter is an electrical instrument for measurement of voltage.

伏特計是用來測量電壓的儀表。

And the excitation voltage and output were also fed through the selector switch to the digital voltmeter.

其激勵電壓和輸出也通過選擇開關接到數字電壓表上。

Ammeter , voltmeter , bridge and similar common methods are typical equipment types .

電流表、電壓表、電橋以及類似的常見儀器都屬于常用的設備。

Fig 3. Typical system to make I-V curves on solar cells, consisting of a current source and voltmeter.

圖3.對太陽能電池進行I-V曲線測量的典型系統，由一個電流源和一個伏特計組成。

The resistance can be measured by employing the ammeter and voltmeter.

電阻可以通過電流表和電壓表測得。

There is no longer the need to investigate the site using a voltmeter so time savings are made.

不再需要調查使用電壓表，因此節省時間進行的站點。

Volt general receive switch device should have a voltmeter(with changeover)and a ammeter.

380伏總受電開關裝置應設置一塊電壓表（帶轉換開關）和一塊電流表。

I recommend that you have the phone company use a voltmeter to test the ring generator voltage on your line.

我建議你有電話公司使用電壓測試環發電機電壓您行。

It adopts PLC control system, touch screen and digital displayed voltmeter adjustment.

該機采用PLC、觸摸屏自動控制系統及數顯電壓表微調控溫。

If the input leads of the voltmeter are reversed, we have the situation shown in Figure 3-13b.

如果我們把電壓表的輸入引線反向，就得到了如圖3-13b的情況。

The three-pole switch was originally used to switch a voltmeter guard along with the signal lines.

三刀開關最早用于切換伏特計保護及信號線路。

The voltmeter is read to make sure that the panels supply the electric current required.

讀取的電壓，以確保面板供應電流要求。

Figure 2-7 demonstrates the effects of shunt capacitance loading on the input of a typical high impedance voltmeter.

圖2-7說明分流電容對典型的高輸入阻抗電壓表輸入端的影響。

a mimosa's leaves are sensitive to touch; a sensitive voltmeter; sensitive skin; sensitive to light.

含羞草的葉子對觸摸很敏感；靈敏的伏特計；敏感的皮膚；感光的。

If the voltmeter contacts are non-ohmic, they may rectify any AC pickup present and cause a DC offset error.

如果電壓表接點有非歐姆接觸特性，那么它就可能對出現的任何交流干擾進行整流并引起直流偏置誤差。

The voltmeter will read the difference between the two electrometers' buffer outputs, which is equal to the voltage across R2.

電壓表將讀出兩個靜電計的緩沖輸出之間的差值，該值等于R2上的電壓。

direct current voltmeter descending to the lowest location.

直流電壓表指針降置最低后方可進行！