stick-slip
美 
英
英漢解釋
例句
Wheel squeal is associated with a complex combination of creepage and a mechanism known as stick-slip.
車輪的尖嘯噪聲與蠕滑及粘滑的組合機械運動有關。
The abrupt disappearance of stick-slip at the lower speed level is attributed to changes in the elastic deformation of the fiber.
在低速水平時，粘滑現象也消失，這是由于纖維彈性變形的改變。
The results showed that the criterion can correctly predict whether stick-slip will occur directly from working parameters.
實驗結果表明，使用該判別式能夠直接根據工況參數正確預測氣缸是否出現爬行現象。
The torque feedback system is a successful technology for eliminating stick-slip vibration of drill-string assembly.
扭矩負反饋減振是控制和消除鉆柱周向粘滑振動較為有效的方法之一。
Stick-slip flow is a jerky movement of compacted grains with velocity of particles at the walls slightly lower than in the rod like core.
粘附滑移流動是一種密集顆粒的急跳式的運動，在壁面處，顆粒的速度稍低于呈桿狀的中心的速度。
The system steady-state error and the stick-slip phenomenon caused by the nonlinear friction are analyzed.
分析了由非線性摩擦力矩引起的系統穩態誤差及粘滑振蕩現象；
The friction between gabbro and marble exhibited stick-slip with visible displacement weakening.
輝長巖與大理巖之間的摩擦出現粘滑，位移弱化現象非常顯著。
there is no stick-slip effect of rolling contact bearings, starting torque is small, run a small friction.
滾動接觸軸承沒有粘滑效應，起動轉矩小，運行摩擦力小。
This same stick-slip mechanism has been strongly implicated in the formation of short-pitch corrugation and associated roaring noise.
短波的波浪磨耗的形成及由此產生的轟鳴噪聲也與這種粘滑機械運動密切相關。
It will also provide additional diagnostics on stick slip, shaft integrity, and maximum and minimum torque.
其還將提供額外的粘滑運動診斷，軸的完整性和轉矩的最大化和最小化。
The results show that Huangcaoba faults latest activities for the holocene early, and fault was dominated by stick slip.
結果表明黃草壩斷層最新活動時代為全新世早期，且活動方式以粘滑為主。
Once the force generating the creepage is spent by the sliding 'action, the stick-slip process begins again (Figure 1).
當產生蠕滑的力被滑動過程消耗以后，下一個粘滑過程又會重新開始。（見圖1）
The goal of the study is to develop a system to measure temperature change in the operation of the stick-slip actuator.
本次研究的目的是開發一種溫度測量系統來測量粘滑驅動器在運行中的溫度變化。
to ensure continuous and stick-slip free operation.
為確保持續和聲滑自由運作。
The friction plays an active role in the stick-slip actuator.
摩擦在粘滑驅動器中具有積極的作用。
Sun Waylubes 1180 and 1190 can improve machining precision due to elimination of stick-slip and chatter of slideways .
太陽1180和1190導軌油可以消除粘著與滑動的合并動作或震動的現象，故可以提高機械加工的精密程度。
In order to eliminate the stick-slip phenomenon, a linearization of the nonlinear model is made at the middle point of the cylinder.
為了消除爬行運動，在氣缸中間位置對系統非線性模型實行局部線性化，分析提出壓力反饋和摩擦力動態補償的方法。
For limestone no stick-slip was observed.
石灰巖實驗未觀察到粘滑現象。
the stress drop and axial displacement in stick slip were much less than that in the eventual fracture.
粘滯時的應力降和軸向位移的變化比斷裂時要小得多。
Macroscopic and Microscopic Evidence of Periodical Stick-Slip Deformation in an Active Fault
活動斷層周期性粘滑變形的宏觀和微觀證據
Modeling of a Stick-slip Friction Pair and its Application on the Dyanmics of Railway Vehicles
磨擦副仿真模型研究及其在機車車輛動力學中的應用
Numeric Simulation on Destructive Effect of Golmud- Lhasa Railway Resulting in Stick-Slip Movement of the Eastern Kunlun Fault
東昆侖斷裂粘滑錯動對青藏鐵路變形效應的數值模擬
Mechanism Analysis on Torsional Stick-slip Vibration of Drillstring in Extended Reach Well and Some Ways to Its Suppression
大位移井鉆柱粘滑振動機理分析及減振研究
Study on Hydraulic Limps Depart Stability in the Stick-slip Friction Effects on the Hydraulic Elevator Actuator
液壓缸粘性摩擦對液壓電梯起動平穩性影響的研究
Control of Stick-slip Phenomenon on Silicon Interface under Relative Humidity Conditions
環境濕度下硅材料表面的粘滑行為及其抑制
Analysis on stick-slip resulted in hydraulic system of machine tool and its elimination
機床液壓系統產生爬行原因分析及消除
Simulation Analysis of Stiffness and Dampness Ratio for the Stick-slip of Machine Tool
剛度和阻尼比對機床爬行影響的計算機數值模擬
Stick-Slip Criterion of Unsymmetrical Cylinders Driven by Meter-Out Circuit
出口節流調速非對稱氣缸的爬行判別式
Modeling of the Motion and the Estimation of Stick-slip in Pneumatic Cylinders
氣缸運動建模及爬行現象判別
Present research situation and analysis on machine tool stick-slip motion
機床低速爬行研究現狀及分析
The Simulation and Active Control Measure of Stick - slip Motion of Machine Tool
機床爬行的仿真研究及控制措施
A Solution of Stick- Slip Motion and Hysteresis for Pneumatic Control Valves
氣動控制閥控制系統爬行和滯后問題的解決方法
Modelling and Simulation of Stick-slip Motion in Pneumatic Cylinder
氣缸爬行現象的建模與仿真
Nonlinear Stick-slip Friction Compensation for DC Motors
一種直流力矩電機系統的滯滑摩擦補償方法
Motion Model and Vibration Equation of Machine Tool Feed System in Stick-slip
機床進給爬行時的運動模型與振動方程
Study on Criterion about Overcoming Low-Speed Stick-Slip of Simulator
仿真轉臺克服低速滯滑的判據研究
Dynamic Analysis of Miniature Piezoactuator Using Stick-Slip Friction Model
基于粘-滑摩擦力模型的微型壓電驅動器動力學分析
Optimal control of low speed stick-slip motion of hydraulic servo system
液壓伺服系統低速爬行的最優控制
Research on Measurement System of Stick-slip Signal in Machine-Tool
機床爬行信號測試系統研究
Stick-slip Criterion of Cylinder Based on Experiment and Dimensional Analysis
基于試驗-量綱分析法的氣缸爬行判定式研究
