haz
美 
英
- n.焊接件的受熱區
- 網絡熱影響區(heat affected zone)；焊接熱影響區；熱影響區域
英漢解釋
例句
The results show that the welding thermal-cycle on its mechanical property of the HAZ has no evidence effect.
結果表明，焊接熱循環對其熱影響區的性能沒有明顯的影響；
The weld section looks like an inverted trapezia and the heat affect zone (HAZ) is very narrow.
焊縫截面呈上寬下窄的倒梯形，熱影響區（HAZ）相當窄；
Fibrous processing marks remain in the heat-affected zone (HAZ) with part of precipitated solid phase solved into the base metal.
熱影響區內，仍可見纖維狀加工痕跡，部分析出相固溶到基體中；
The microstructure of weld bead obtained by shielded metal arc welding are massive ferrite and a little pearlite, HAZ are lath bainitic.
手工電弧焊焊縫組織主要為塊狀鐵素體和少量珠光體，熱影響區組織為板條狀貝氏體組織；
The microhardness distribution of the welded joint is along the welding line. The microhardness is higher in nugget zone, and lowest in HAZ.
焊接接頭的硬度分布沿焊縫中心基本對稱，焊核區硬度較高，熱影響區硬度最低。
high strength pipeline steel pipes and its welding HAZ shall have well properties of low temperature toughness and site girth welding.
以得到同時具備高強度、良好的低溫韌性和現場焊接性能的管線鋼。
This paper discussed the effects of Nb on the HAZ structure and properties of ultra-fine grained steel formed by the deformation inducement.
討論了以形變誘導相變為主的超細晶粒鋼在添加合金元素鈮以后熱影響區組織性能的變化。
The HAZ will have O temper annealed properties for non-heat-treatable alloys regardless of the initial material temper.
對于不可熱處理的合金，HAZ將會得到基礎狀態O的退火性能。
the HAZ was martensite and a small amount of residual austenite.
熱影響區為馬氏體組織和少量殘余奧氏體。
The dominant nucleation mechanism of IAF in HAZ of different micro-alloyed series was not the same as each other.
不同微合金化系列占主導地位的IAF形核機制不盡相同。
The results indicated that excellent low temperature toughness and lower FATT could be obtained under different welding conditions in HAZ.
結果表明：在不同焊接條件下，此類鋼焊接熱影響區均具有較好的低溫韌性和較低的韌脆轉變溫度。
The grain distribution and heat pining of grain growth in the welding HAZ. Different influence were predicted by different heat input .
預測了HAZ中晶粒的分布，以及不同的熱輸入對HAZ晶粒長大的影響和HAZ中晶粒長大的熱釘扎效應。
A recent vice president, Hamzah Haz, bragged about his polygamy, taking his three wives on trips to Mecca.
曾任印尼副總統的哈姆扎?哈茲（HamzahHaz）曾經公開炫耀他的多重婚姻，帶他的3位太太去麥加朝圣。
Fracture toughness of heat affected zone (HAZ) was between the base metal and weld metal.
焊接熱影響區的斷裂韌性介于母材和焊縫金屬之間。
The test result shows that jointer weld is typically ferrite and pearlite structure, HAZ contains side strip ferrite.
試驗結果表明，該鋼焊接接頭焊縫為典型的鐵素體和少量的珠光體組織，HAZ（熱影響區）含有側板條鐵素體。
On the basis of the microhardness variation, the HAZ is divided into five subregions .
根據顯微硬度的變化，將焊接HAZ分為五個區段。
With the increase of yield strength, the longitudinal residual stress of HAZ increases.
且隨著焊縫強度增加，熱影響區縱向殘余應力增加。
The hardness of the weld zone is higher than that of matrix and the hardness of heat affected zone(HAZ) is lowest.
焊縫區顯微硬度最高，其次是母材，熱影響區硬度最低。
declining of mechanical performance in welding seam and welding heat affected zone(HAZ) etc.
焊縫和焊接熱影響區力學性能下降等不足。
The microhardness of weld metal zone, HAZ and base metal decrease in totality after heat treatment.
焊縫區、熱影響區與母材的顯微硬度整體呈下降趨勢；
Toughness distributions of different area on HAZ of grade X80 pipeline steel have been studied.
研究了X80級管線鋼焊接熱影響區不同區域的韌性分布。
Both FZ and HAZ have higher microhardness than the base metal has, and microhardness in fusion centre zone is the lowest.
熔合區和熱影響區的顯微硬度顯著高于母材，焊縫中心區在整個焊縫部分硬度最低。
There ate a small amount of martensite in HAZ, and distributed in gradient.
熱影響區中存在少量細小馬氏體組織，且呈梯度分布。
The micro-structure of fracture surface of HAZ is of granular bainite, with characteristics of coarse crystal zone.
熱影響區斷口表層剖面組織為粒狀貝氏體，顯示出粗晶區的特征。
It was shown that the impact toughness of HAZ is 50% of base metal.
結果表明，該鋼的焊接熱影響區的沖擊韌性較母材降低50%以上；
Too slow a cooling rate can result in a soft HAZ and thus a loss of tensile and fracture toughness properties.
如果冷卻率太慢，則會導致軟焊接，張力減少和韌性變脆。
The results show that dislocation starts to glide in HAZ.
結果表明：熱影響區位錯開始滑移；
Any arc welding process gets the HAZ much hotter than this.
電弧焊接工藝將使HAZ（焊接熱影響區）比這個更熱。
The actual welding test show that the grain size number in HAZ is above NO. 6.
對該鋼種進行了實際焊接試驗，檢測結果表明熱影響區的晶粒度在6級以上。
Four kinds of welding joints all have good low-temperature impact toughness except HAZ on 1. 4003 side.
除1.4003側HAZ外，四種焊接接頭均具有良好的低溫沖擊韌性。
Impact Charpy toughness and local brittleness of HAZ of X80 line pipes made in China were studied.
研究了國產X80級管線鋼熱影響區的沖擊韌性和組織的局部脆化。
Prediction of HAZ tribological properties of fusion welded zinc-based alloy by means of artificial
基于人工神經網絡的鋅基合金熔化焊HAZ摩擦學性能預測
Flow behaviors of HAZ-softened weld joint and prediction of its tensile strength
熱影響區軟化焊接接頭流變行為及抗拉強度預測
Effect of welding thermal cycle on HAZ microstructure and mechanical properties of copper-bearing age-hardening steels
焊接熱循環對含銅時效鋼HAZ組織與力學性能的影響
Study on HAZ microstructure and impact properties in high strength shipbuilding steel plate
高強度造船板熱影響區組織和沖擊性能的研究
Effect of simulated welding thermal cycle on microstructure and properties of HAZ for micro-calcium steel
焊接熱循環對微鈣鋼組織性能的影響
Narrowing HAZ During Induction Heating for Friction Welded Joints of High Strength Steel
高強鋼摩擦焊接頭感應加熱區寬度窄化技術
Monte carlo computer method for simulating microstructure evolution in HAZ of welds
焊接熱影響區微觀結構演化的蒙特卡羅計算機模擬方法
Modeling and experimental study on HAZ grain growth in laser welding of ultra-fine grained steel
超細晶粒鋼激光焊接HAZ晶粒長大的數學模型及實驗研究
Microstructure simulation in the HAZ of industrial pure aluminum
工業純鋁焊接熱影響區微觀組織模擬
