psid
美 ['s?d]
英 ['s?d] 
- 網絡壓差;Panel Stuay of Income Dynamics;安全標識符的指針
英漢解釋
例句
Open TC #2. When flow of water out of TC #2 stops, the differential reading is the pressure drop. Record (must be 1 PSID or more).
開啟測試旋塞2號。當測試旋塞2號流出的水停止時,則壓差讀數就是壓降。記錄(必須是1PSID或以上)。
If the reading returns to +PSID, No. 2 shutoff valve is leaking excessively and must be replaced to test the valve.
如果讀數恢復到+PSID,則2號關閉閥泄漏過于嚴重,必須對其更換,以便進行閥門的檢測。
When dripping from bleed screw stops and PSID needle on gauge stabilizes, record the differential pressure .
當從排氣螺絲上的滴漏停止時,儀表上的PSID指針穩定下來,則記錄壓差。
Requirement: Differential pressure across check must be 1. 0 PSID or above.
要求:通過止回閥的壓差必須在1.0PSID及以上。
Requirement: Supply pressure drop must be 1. 0 PSID or more when water flow stops from test cock No. 2.
要求:當水流從測試旋塞2號上停止時,供應壓降必須在1.0PSID及以上。
Requirement: Supply pressure drop must be 1. 0 PSID or above when water flow stops from test cock No. 2.
要求:當測試旋塞2號的水流停止時,供應壓降必須等于或大于1.
Slowly open VA and lower high side pressure about -2 PSID below the low side pressure (differential reading about -2. 0 PSID ).
慢慢開啟閥門A,并且降低高端壓力使其比低端壓力低大約-2PSID(壓差讀數大約為-2.0PSID)。