annealed
美 
英 [?'ni:ld]
- v.給…上釉；【冶】使韌化；〈比喻〉鍛練(意志)
- 網絡退火；退火的；退火狀態
詞形變化
過去分詞：annealed 現在分詞：annealing 第三人稱單數：anneals 同義詞
英漢解釋
英英解釋
例句
The washer is usually made of annealed nickel and has a highly polished surface.
墊圈通常用退火鎳制成，具有非常光滑的表面。
Hot rolled stainless steel bars that are annealed and cold worked to produce a higher surface quality and higher strength.
經過退火及冷加工的熱軋不銹鋼棒材，其表面質量更高，強度也更高。
When gill hole was enlarged and handlers was formed after annealed, the surface shallow crack and chap appeared.
當鍛件退火后進行鰓孔擴口和柄部弧形彎曲時，過熱和過燒的缺陷引起表面淺層裂紋和龜裂。
Bearing cones must be annealed prior to machining and a subsequent post heat-treat hardening.
退火軸承錐必須事先向加工和隨后的后熱處理硬化治療。
In this paper the annealed structure and its grade of bearing steel with abnormal original structure have been studied.
本文研究了非正常原始組織的軸承鋼，退火后的組織及其評級問題。
The copper is slowly drawn through the die in extremely small increments and is annealed following each drawing operation.
銅正在慢慢穿過死在非常小的增量和退火以下是每個繪圖作業。
Temper-all material shall be thoroughly and evenly annealed, and dead soft, unless otherwise specified by the purchase order.
除非采購訂單另有規定，否則所有材料的回火應該徹底而均勻地退火，完全軟化。
Other flat-rolled products of stainless steel, hot-rolled, not annealed and pickled, not in coils, of a thickness exceeding 10 mm.
其它熱軋不銹鋼扁軋制品，未經熱軋退火酸洗，非卷盤狀，厚度超過10公厘者。
The experiments show that the microstructure of annealed sample is favourable to improving reverse breakdown voltage.
實驗表明，退火后樣品的微觀結構有利于提高反向擊穿電壓。
When it is annealed, amount of cokes are put into the furnace which is sealed up to prevent the oxidization of mould.
在進行退火處理時，退火爐內放入一定量的焦炭，并且將爐門四周密封，防止鑄鋼件表面氧化。
The HAZ will have O temper annealed properties for non-heat-treatable alloys regardless of the initial material temper.
對于不可熱處理的合金，HAZ將會得到基礎狀態O的退火性能。
According to the size of carbides and the amount of exposed matrix, the annealed structure can be divided into low and high grades.
認為可以根據碳化物顆粒大小，基體露出多少為主的原則，把其分為低級別組織和高級別組織進行參考評級。
The variation of the texture and magnetic properties of non-oriented silicon steel after being cold-rolled and annealed is studied.
對冷軋及退火后無取向硅鋼織構及磁性能的變化進行研究。
Bending can be done in a umber of ways, but prior to this, the lever must be annealed so that it doesn't crack during reforming.
彎曲的方式進行，可在一個單位數目，但在此之前，必須退火的杠桿，以便它在改革不開裂。
Most nonferrous metals can be annealed, but never tempered, normalized, or case-hardened.
而大多數有色金屬可以進行退火，但不能進行正火或者表面硬化。
The resistivity of pyrophosphate and annealed acid sulfate copper deposits are substantially equivalent.
焦磷酸鹽和退火后的酸性硫酸銅沉積物的電阻性是基本等效的。
In the first, it is annealed, meaning it is run through a furnace to be softened.
在第一，它是退火，這意味著它是通過一爐運行到軟化。
A. For annealed drawn tubes the ratio of outer diameter to thickness is no more than 15.
退火態拉制管外徑與壁厚之比不小于15者。更詳細。
However, the forward martensitic transformations were greatly suppressed in annealed Co and CoNi.
然而鈷和鈷鎳中的馬氏體正相變則大大的壓制。
which appeared quite different from aforementioned results obtained from the annealed ZnO sample.
出現上述結果不同從退火氧化鋅樣品。
Lead or annealed copper washers are most often used in fluorine and other reactive fluoride service.
鉛或退火銅墊圈最經常用于氟和其它活潑氟化物設施。
The effect of different annealed process on the property change of the resistance thermostat metal is investigated.
本文研究了不同的退火工藝對電阻系列熱雙金屬性能產生的影響。
The EDS analyses also suggest the presence of burnt carbonaceous residues on the annealed sheet surface.
有關的EDS分析還表明，存在燒毀的碳質殘留對退火板表面。
CASTING TO BE ANNEALED AND FULLY STRESS RELIEVED.
鑄造將予應力退火和時效處理。
The samples prepared were annealed in air atmosphere at different temperatures.
在空氣中對樣品進行不同溫度的退火處理。
Therefore, the design must be based on the annealed properties, not on the strain-hardened properties.
因此，設計必須基于退火性能，而非應變硬度性能。
Standard Specification for Annealed Copper- Clad Steel Wire . Pdf.
退火火銅包覆鋼絲電線規范。
If a CroMo frame is not heat treated after welding, the joints subjected to heat during the welding process are annealed or normalized.
如果CroMo框架焊后不熱處理，關節受高溫焊接過程中退火或正?；?/c>。
While the oxide scale of the 316 steel annealed in air was quite complicated and has a very poor bonding with the substrate.
而在空氣爐中生成的氧化層結構復雜，和基體的結合強度非常低。
The change rule of the microstructure of the coldrolled Sisteel annealed under different current was researched.
研究了不同電流條件下退火冷軋無取向硅鋼組織的變化規律。
A series of improving technical methods were addressed for arising the quality of annealed metal base.
為提高金屬坯條光亮退火的質量，提出了一系列工藝改進的方法。
In this process the cold rolled annealed strips are given a desired surface finish.
在這一個加工，卷退火的分帶寒冷有一個被需要的表面光制。
The precipitated phases in cold rolled and annealed thin steel strip are nano-scaled M3C and nano-scaled MC.
冷硬板和退火薄板中的析出相主要為納米級的M3C型和MC型析出物。
Appreciate those who hurt you, because he annealed your mind.
感激傷害你的人，因為他磨練了你的心志。
And cracks appear in the film because tensile stress is too large when the sample is annealed at 400 centigrade.
在400℃退火后，由于張應力太大，薄膜表面出現了裂紋。
Annealed tool steel can readily be machined.
加熱退火工藝煉鋼能通過機械簡單完成。
At the second one, the products in the first step were annealed at different temperatures to obtain 1-D ZnO.
第二步驟則是將前一步驟的產物經過不同溫度的退火處理來得到一維氧化鋅材料。
Irradiation creep of annealed 304L stainless steel at low dose levels.
在低劑量水平下退火304L不銹鋼的輻照蠕變…[中國核科技信息與經濟研究院]。
Hardened steel is difficult to machine, but having been annealed, it can be easily machined.
淬火鋼難于加工，但是經退火后就易于加工了。
for annealed metals, it is about five times Y.
而對于退火材料來說，則大約是五倍。
