burr

美 [b?r] 　英 [b??(r)]

• n.小舌 r 音；（機器部件快速運轉時有規律的）呼呼聲
• v.用粗喉音說(話)；用粗喉音說話
• 網絡毛邊；毛刺；毛頭

詞形變化

同義詞

英漢雙解

英漢解釋

英英解釋

例句

After twenty years as a teacher, Mr Burr called it a day and retired.

做一名教師做了二十多年，伯爾先生決定到此為止，退休了。

Burr might have been the president instead of vice president, had it not been for Hamilton's interference.

如果不是漢彌爾頓的介入，安倫波當時可能成了美國總統，而不是副總統。

Bakery boss to see him over, cordial, said: "Little Burr, today what you want bread? "

面包坊的老板見他過來，親切的說：“小伯爾，今天想吃什么面包？”

Burr, the dust particles in the fixed network is possible when punctured whee caused the rupture of the mesh fabrics complete Board.

毛刺、沙粒在固網時有不定會刺破網布變成整板網布的分裂。

Once again retract the burr hole site, and fold back the Micro Sensor completely at the desired bend side to leave a kink in it.

再次收縮單孔處，在指定段將微傳感器完全彎曲并留下一個扭結。

should be installed in the burr, clean and remove the stolen goods, do not make it into the pipe to prevent blockage of the trachea.

安裝時應將毛刺、贓物去除干凈，不要使其流入管道，以免堵塞氣管。

The surface of the syringe must be clear and pure; rough edge, burr, plastic stream, defect are not allowed.

注射器表面必須清潔無雜質，不得有毛邊、毛刺、塑流、缺損等缺陷。

The burr in the surface and grooves can be eliminated obviously thus getting a high surface precision and smooth finish.

有效地去除換向器表面及槽口的毛刺，提高其表面精度和光潔度。

Even if the lifespan is known as the Tie Shan Hui Kwong Kam, although the tail of a burr, but the actual view is also very beautiful.

即便是被稱為鐵扇的壽惠廣錦，雖然尾部有毛刺，但是實際看來也是很漂亮的。

The Si-Mn steel track plate and pin usually exist the early abrasion, one of the main reasons is the burr defect of pin hole.

硅錳鋼履帶板銷孔存在脈紋鑄造缺陷是造成履帶板與履帶銷出現早期磨損現象的根本原因之一。

"The initial reasons Burr's office gave for opposing the Act was that smooth dogfish are unique, " Toomey said.

“Burr的辦公室一開始反對該法案的原因是大星鯊的稀有性，”Toomey說。

Carefully pull back the access line. The kink should be in the bottom of the burr hole.

小心的往后拉入顱線，扭結應處于單孔的底端。

Riveting part, should firm do not become loose, rivet round head and periphery should be not had glossily break mark or burr.

鉚接部分，應牢固不松動，鉚釘圓頭及周邊應光滑無砸痕或毛刺。

There is no such defects as crack, air bubble, burr on the surface of sanitary unit, the color wait for Owner's decision.

衛生單元內表面裝飾應完善。無裂縫、氣泡、毛刺現象，顏色待定。

Bevel the burr hole on the edge of the side where the Micro Sensor will exit. This will facilitate removal of the Micro Sensor.

在微傳感器探出的邊將單孔削成斜角，這能輔助微傳感器的移走。

No burr, flash, scratch, flow mark , bright speck , shrinkage defects etc on the surface of product.

外觀表面不可有毛邊、刮痕、流痕、亮痕、縮水等不良現象。

The ability to register the burr was useful to clear the lesion without removal of any excess bone.

校正鉆孔器的作用是清理病灶而免于切除任何過多正常骨。

Last month the Washington University surgeons drilled a small burr hole, about the diameter of a pencil, into the patient's skull.

上個月華盛頓大學的外科醫生用鉆孔器在這個病人的頭骨上鉆了一個洞，直徑大約和鉛筆一樣。

The rubber powder easily with other rubber-binding, which is fine and uniformity and its surface with a large number of burr.

所得膠粉細而均勻且粉體表面帶有眾多毛刺形，易與其它膠體結合。

The burr is one of the common phenomena occurring in metal cutting operations.

金屬切削毛刺是切削加工的常見現象，它直接影響到工件的加工精度。

Provided with a burr-trimming cutter, the bias-adjustable device can remove automatically the burrs on the polished rod.

調偏裝置設計有光桿修復刀，可自動修除光桿上的毛刺。

This form of scar treatment uses a motorized burr , which usually contains diamond particles .

這種形式的瘢痕治療用摩托毛刺，通常含有金剛石顆粒。

The results show that the burr shape of the Ni powders can increase the conductivity and decrease the percolation threshold of the coating.

結果表明，導電鎳粉由于具有毛刺狀突起，因此可以增加涂層的電導率，降低滲濾值；

Hamilton, the former secretary of the treasury, and Vice President Burr were longstanding political rivals and personal enemies.

前財政部部長漢彌爾頓與副總統安倫波長久以來的政治立場就互相對立，也是彼此的敵人。

Briefed are the process and equipment configuration of the inner burr-removing system for ERW straight welded tubing.

簡述了ERW直縫焊管清除內毛刺的方法及設備構成；

The burr is one of the common phenomena occurring in metal cutting.

毛刺是金屬切削加工中產生的常見現象。

In a Washington File interview, Burr said most people would agree that such "user-empowering" technology is important for families.

伯爾在接受《美國參考》采訪時說，大多數人都認為，這種所謂“用戶自主”的技術對家庭來說是很重要的。

Finally, the influence of cutting parameters and tool wear on burr formation are studied through the experiment of machining micro-flute.

最后，本文針對微槽切削加工過程，分析了切削參數和刀具磨損對工件毛刺形成的影響。

The size and morphology of two side direction burr vary with grinding-hardening conditions.

兩側方向毛刺的形態及尺寸隨著磨削淬硬加工條件的變化而異。

Briefed in the article are the inner burr formation of and the burring method for the hi-frequency straight welded tube.

簡要介紹了高頻直縫焊管內毛刺的形成和清除方法。

Furthermore, some methods to restrain or decrease the two-side direction burr in grinding-hardening machining are developed.

同時，給出了若干抑制或減少兩側方向毛刺的方法。

The exactness of the method is verified by the calculated illustrations of milling cutter and burr.

文中的銑刀及旋轉銼的計算實例驗證了本文的算法正確。

The winter's frost must rend the burr of the nut before the fruit is seen. So adversity tempers the human heart, to discover its real worth.

只要冬天的寒霜撕碎了堅果的芒刺，才能看到果實。因此，逆境能煉就一個人的心，發現這顆心真正的價值。

Objective To investigate the operative experience and curative effect of improved burr hole and drainage for chronic subdural hematoma.

目的探討改進單孔引流治療慢性硬膜下血腫的臨床療效。

When Burr's term as vice president was almost over, he ran for governor of New York.

當安倫波的副總統任期即將屆滿的時候，他參加了紐約市市長的競選。

Conclusion The improvement of the burr hole and drainage for chronic subdural hematoma is simple . . .

結論單孔引流治療慢性硬膜下血腫，操作簡單，療效確切，并發癥少。

L team to cooperate, be responsible for the product, main job is to remove rough machined surfaces burr.

l團隊分工合作，負責完成產品的粗加工，主要工作為去除零件表面毛刺。

Burr argued that if the fins are not removed, the fins become spoiled because of migration of urea from the body to the fins after death.

Burr爭辯說如果不講魚翅割下，鯊魚死后尸體中的尿素會進入魚翅讓其變質。

Burr-Brown makes a number of specialized analog-to-digital converters for touch screen applications.

伯爾-布朗作出了專門的申請數目模擬到數字轉換器觸摸屏。

This paper deals with the partial electrolytic method which is applied to de-burr cross-hole inside aluminium cylinder of electric hammer.

本文采用局部電解法去除電錘鋁氣缸交叉孔內壁毛刺。